biodex ATOMLAB 100 - Determining Firmware Level; Procedure to Determine Firmware Level

APPENDIX I:
DETERMINING THE FIRMWARE LEVEL OF
YOUR DOSE CALIBRATOR
Use the following procedure to determine the firmware level
of your Atomlab 100 Display and Chamber Units.
1) Press SETUP four times.
2) Press TEST. The Display Unit firmware level will appear
on the Electronic Thumbwheel Display.
3) Press TEST again to display the Chamber Unit
firmware level.
4) Press TEST once more to display high voltage.
5) Press TEST once more to return to the isotope
value setting.
1) Press SETUP to return to the normal operating mode of
the system.
ATOMLAB Dose Calibrator Operation Manual Appendix I
Biodex Medical Systems I-1 Release 2.0