DETECTOR CABLE
10 ft. (3.1 m)
Six total: two for power, one for chassis ground, three for serial
data.
AMP Mate-n-Lock, white with hooded strain relief.
FRONT PANEL
Four digit, seven segment red LED, 0.57 in. (14.5 mm)
high, four floating decimal point indicators between digits.
Four discrete inscriptions back lit with large red LEDs: mCi,
µCi, MBq or GBq (right adjacent to digits).
Momentary contact, rubber with conductive pad.
Adjacent red LED to indicate selection.
I-131, In-111, Ga-67, Xe-133, I-123, Tl-201, and
Tc-99m.
Each key has a pre-assigned Calibration Value for activity
measurements in a standard syringe or vial form.
Keys can be reset for new Calibration Values.
The Mo-99 key is calibrated for Mo-99 assay in a shielded vial
of Tc-99m. The Atomlab 100 provides a 30-second countdown.
Co-57 and Cs-137: used for accuracy and constancy
checks.
OTHER, 1, and 2: allows activity display of other isotopes. In
Setup mode the OTHER key selects units.
Four digit, seven segment red LED, 0.27 in. (6.9 mm) high,
with colon between second and third digits, and three float-
ing LED decimal point indicators between digits.
ATOMLAB Dose Calibrator Operation Manual Appendix B
Biodex Medical Systems B-4 Release 2.0
Length
Conductors
Connectors
Activity Display
Activity Units
All Keys
Isotope Selection
Keys
Calibrator
Constancy
Isotope Keys
Other Isotope Key
Electronic
Thumbwheel
To Next Page
Loading...