APPENDIX E:
CALIBRATION VALUES
FOR VERSION SIX FIRMWARE OTHER ISOTOPE
SELECTIONS
OVERVIEW
This appendix provides Calibration Values which you may
use to program the non-standard Isotope Selection keys of
your Atomlab Dose Calibrator.
These values are dependent on the firmware level of your
Chamber Unit. Atomlab users with firmware level six or
above should refer to Chart A on page E-2. If your firmware
level is five or less, refer to Chart B on page E-6.
To determine the firmware level of your dose calibrator, refer
to Appendix H.
For Y-90, be sure to see the section "Dial Settings
for Y-90", at the end of this chapter.
ATOMLAB Dose Calibrator Operation Manual Appendix E
Biodex Medical Systems E-1 Release 2.0
To Next Page
Loading...