E30 Digital Electrocardiograph User’s Manual
4-1
Chapter 4.Operation Instruction
4.1 Turn On/Off
Using AC power supply:
——Turn on: Press the power button after connecting the power cord, the
screen displays the start interface, and then enter work mode.
——Turn off: Press power button, and screen will display “The device is
shutting off…”, when the prompt info is over, the device is power off. Then
unplug the power pin.
Note: When powering off is not work, pressing power button lasting
5s can force to turn off.
Using battery:
——Turn on: Press the power button, the screen displays the start interface,
and then enter work mode.
——Turn off: Press power button, and screen will display “The device is
shutting off…”, when the prompt info is over, the device is power off.
Warning:
Advert to status of patient and device at any moment;
If the electrocardiograph is mechanically damaged, or if it is not
working properly, do not use it for any monitoring procedure on a
patient. Contact your service personnel.
4.2 Main Menu
Enter the monitor interface by press the power button of the
Electrocardiograph, then press the “ ” button to enter the main menu.
Shown as following chart:
0
)
To Next Page
Loading...