Biolight Meditech E30 - System Setup

E30 Digital Electrocardiograph User’s Manual
4-10
of system after recording of a patient.
——Select【Default medium】: May select one auto save medium according
to actual needs, i.e. Flash, SD card or U disk.
——Select【Measure】: May select 【Display】 or 【Not display】. Result
of the ECG waveform measurement will be exported while selecting
【Display】, otherwise, it will not.
——Select【Analyze】: May select 【Display】 or 【Not display】. Record
of ECG automatic analysis result will be exported at the time of ECG
recording while selecting 【Display】; otherwise, it will not.
——Select【Patient info】: May select 【Display】 or 【Not display】. Record
of the ECG data collected will be exported while selecting 【Display】,
otherwise, it will not.
——Select【Sampling mode】: Optional: Pre-sample, Real-time sample and
Trigger sample.
1) When 【Pre-sample】 is selected, collection of ECG data begins as
soon as lead is connected to patient; it is unnecessary to wait for the
user to press “ ” before beginning collection of ECG data.
When the user press “ ”, record of the ECG data collected
within 10s before pressing this key will be exported;
2) When 【Real-time sample】 is selected, if the user press “ ”,
record of the ECG data collected within 10s after pressing this key will
be exported;
3) When 【Trigger sample】 is selected, if the user press “ ”,
Electrocardiograph will automatically trigger record once in case of
arrhythmia.
After setup of report info, select 【OK】. If 【Default】 is selected, the
device will resume the default set of manufacturer.
4.8 System Setup
Press 【System】 in main interface to enter system setup interface. Shown
as following chart: