Hazards and Precautions| 87
Warning! Ultrasonic Energy. Ultrasonic energy is present in the
ultrasonic cleaner reservoir (if equipped) when AUTOCLEAN/Quick Clean
programs are running. Avoid putting your fingers in the bath. Ultrasonic
energy can be destructive to human tissue.
Warning! Software Quality Control. The operator must follow the
manufacturer’s assay package insert when modifying software
parameters and establishing washing or dispensing methods. Failure to
conduct quality control checks could result in erroneous test
data.
Warning! Internal Voltage. Always turn off the power switch and
unplug the power supply before cleaning the outer surface of the
instrument.
Warning! Potential Biohazards. Some assays or specimens may
pose a biohazard. Adequate safety precautions should be taken as
outlined in the assay’s package insert. This hazard is noted by the
symbol shown here. Always wear safety glasses and appropriate
protective equipment, such as chemically resistant rubber gloves and
apron.
Warning! Pinch Hazard. Some areas of the instrument or its
components can present pinch hazards when the instrument is
operating. Depending on the instrument or component, these areas are
marked with the symbol shown here. Keep hands/fingers clear of these
areas when the instrument is operating.
Precautions
The following precautions are provided to help avoid damage to the instrument:
Caution: Service. The instrument should be serviced by BioTek
authorized service personnel. Only qualified technical personnel should
perform troubleshooting and service procedures on internal components.
Caution: Spare Parts. Only approved spare parts should be used for
maintenance. The use of unapproved spare parts and accessories may
result in a loss of warranty and potentially impair instrument performance
or cause damage to the instrument.
BioTek Instruments, Inc.
To Next Page
