BP-007 User’s Manual
- 50 -
FS - Set Chinese underline mode
Format: ASCII: FS - n
Decimal: 28 45 n
Hex: 1C 2D n
[Description]
Turns on or off underline mode for Chinese characters, using n as follows:
When n=0, underline has no effect on Chinese characters;
When n=1, Chinese characters are set by single underline mode;
When n=2, Chinese characters are set by double underline mode, but the shift generated by “HT”
command is invalid.
FS 2 Self-define Chinese characters
Format: ASCII: FS 2 a1 a2 d1 d2 d3 …d32
Decimal: 28 50 248 a2 d1 d2 d3 …d32
Hex: 1C 32 F8 a2 d1 d2 d3 d32
[Description]
Define the user-defined Chinese characters.
a1=F8 (Hex); A1 ≤ a2 ≤ FE (Hex).
Chinese code has two bytes: a1 is the first byte and a2 is the second byte.
FS S Set full-size Chinese characters spacing
Format: ASCII: FS S n1 n2
Decimal: 28 83 n1 n2
Hex: 1C 53 n1 n2
[Description]
Set the left-side character spacing to n1 dots; Set the right-side character spacing to n2 dots. Half-size
characters will be put in good order automatically to ensure that the width of full-size character is twice that
of half-size character.
Default: n1=0, n2=2.
FS W Turn quadruple-size mode on/off for Chinese character
Format: ASCII: FS W n
Decimal: 28 87 n
Hex: 1C 57 n
[Description]
Turn quadruple-size mode on or off for multi-byte code character.
When n＝＜*******1＞B, quadruple-size mode is turned on.
When n＝＜*******0＞B, quadruple-size mode is turned off.
GS FF Executes black mark detecting
Format: ASCII: GS FF
Decimal: 29 12
Hex: 1D 0C
[Description]
Execute black mark detecting command. If black mark is detected, the printer stops feeding paper and
returns a value (AAH) by serial interface; If black mark is not detected, the printer feeds paper until to the
end of this page and returns a value (55H) by serial interface.
To Next Page
Loading...
