Rev. 3.02
- 61 -
SRP-270
8-2 Handling the Printer
8-2-1 Precautions on Printer Handling
8-2-1-1 Precautions on transport
1) When trans porting this printer. It’s proper handling method is to support both side of Frame main with
both hands.
2) When trans porting this printer. never grasp it by Ribbon cassette case, PCB Connector , and Solenoid
Assy or other such parts.
3) Never expose the printer to impact by dropping or striking it.
4) Take special care that no foreign matter contacts the PCB at the bottom of the printer.
8-2-1-2 Precautions on storage
1) Avoid storage in locations exposed to excessive dirt or dust, direct sunlight or excessive moisture.
2) In case of long- term storage, place the printer into a polyethylene bag after wrapping it in anti- rust paper,
then store it in a dry location.
To Next Page
Loading...
Need help?
General
