5-9 SWC (Simple Wi-Fi Connect)
• Connect the printer to a network using SWC(Simple Wi-Fi Connect) mode.
** blink rate of “Pulse” is slower than blink rate of “Flash”
• Make sure that media roll has been installed properly.
1) Standard Model
(1) Press the Feed/Cancel button( ) for more than 3 seconds
to enter SWC(Simple Wi-Fi Connect) Mode
(2) The LED status in the SWC mode ready can be as follows.
- LED 1: Green On
- LED 2: Red Blink(pulse)
(3) Printer’s LED1 Green pulse indicates that the printer is in SWC Mode.
you can set network through Host Devices.
- LED 1: Green Blink(Flash pulse)
- LED 2: Green On
(4) Once the network is not set correctly, LED1 will flash Orange,
and try entering SWC Mode again.
- LED 1: Orange Blink(pulse)
- LED 2: Green On
2) LCD Model
(1) Enter SWC(Simple Wi-fi Connect) Mode using buttons. Print ready
Interface WLAN SWC Execute SWC and press Function 1 button( )
(2) Printer’s LCD Display “SWC Mode” indicates that the printer is in SWC Mode.
You can set network through Host Devices
- LCD Display: ”Preparing…” ”SWC Mode”
(3) Once the network is not set correctly, LCD will Display Error Message,
and try entering SWC Mode again.
- LCD Display: ”Password Error Return to SWC mode”
To Next Page
Loading...
