Operating instructions FK 23 Safety instructions
6.066.98.5.10.05 en 3 - 3
3
WARNING Missing components!
The operator can only be protected from injuries and the machine
protected against damage if all the components of the machine are
assembled properly.
– Check if the machine is complete before it is re-started.
– Check if components are positioned correctly and firmly.
– Only use original Bizerba spare parts and accessories.
3.4 Protective and safety equipment
– Door lock, saw protected against switch-on when door open
– membrane keypad, ON switch with protection function against unintended machine
start (increased actuating force), OFF switch responds when slightly touched (re-
duced actuating force)
– Product pusher, product feed unit and saw blade cover
– Protective bar, height adjustable device with upper saw blade guide
Correct functioning of the protective and safety equipment must be reg-
ularly checked.
Check if after opening the door, the saw blade comes to a standstill as
soon as possible (it must not take more than 4 sec.).
The operator must define the frequency of checking.
Remaining risks that cannot be excluded by technical measures:
– Risk of tripping/slipping if the work area is not kept tidy.
– Risk of injury if the required personal protective clothing is not
worn.
To Next Page
Loading...
General