Bizerba FK 23 - Detailed Sawing Cleaning Plan

Maintenance Operating instructions FK 23
8 - 4 6.066.98.5.10.05 en
8
8.4 Cleaning plan Sawing
Work steps Cleaning
agents
Procedure Cleaning devices Note
Preparatory
measures
Switch off the
machine, pull out
power plug.
Disassemble
all removable
parts
in accordance
with instruction
manual
Rough clean-
ing
Remove any
product rem-
nants manually
Plastic deflector,
plastic spatula,
brush
Start immediately
after production
has finished, if nec-
essary, begin with
the removed parts
Cleaning 2% P3 sterile
Contact time
is approx. 15
minutes
after thorough
pre-rinsing with
water (max.
50°C, depend.
on when grease
can be easily re-
moved) foam or
manually
Brush, tray, dis-
posable cleaning
cloth
low pressure
foaming device
smaller than
30°bar
all disassembled
and permanent
parts of machine
* see comment
Disinfect
Additional
measure
0.5- 2% P3
alcodes
Application
time accord-
ing to product
data sheet
spray
foam
Manual spray
device
Low-pressure
foaming device
Add. safety: dis-
tance to surface
when spraying,
0.30 m
Recommended ap-
plication quantity
40-50 ml/m
2
* see comment
Acid cleaning
Additional
measure
max. 3% P3-
riksan
max. 15 mi-
nutes contact
time
manually, me-
chanically
Brush for remov-
ing lime residue
only if required for
lime residue
rinse directly after
cleaning
* see comment
spray
foam
Manual spray
device
Low-pressure
foaming device
Rinse Drinking water Max. 50°C tem-
perature depend.
on when grease
can be easily re-
moved
Water pipe
Low pressure,
lower than 30
bar
rest of machine,
parts removed
* see comment
Check visually on opti-
cal cleanliness