Operating instructions FK 23 Troubleshooting
6.066.98.5.10.05 en 7 - 1
7
7 Troubleshooting
7.1 Fault description
If the saw blade is broken, blocked or stuck, in case of unusual noise,
possible damage or injury, immediately switch the saw off.
Should there be a stoppage and the problem cannot be corrected right
away, food products have to be removed for protection in compliance
with the maximum limit of 30 minutes for products to remain on the ma-
chine.
The described malfunction can be remedied by the user himself.
Malfunction Causes Remedy
Saw cannot be switched
on.
Supply voltage interrupted. Check mains connection.
Saw door not closed properly. Close saw door properly.
Motor circuit breaker respon-
ded due to overload.
Let motor cool down for
some time.
Bad cutting result. Saw blade is dull. Assemble new saw blade.
High cutting pressure and
build up of odors.
Saw blade in reverse position
(tooth direction).
Correct position.
Saw blade flutters. Saw blade is too long (wrong
product).
Position original saw blade.
Saw blade without tension. Bring clamping unit lever in
position 1.
7.2 Procedure
Switch off machine immediately if untypical noises are heard or if there is a suspected
risk of injury.
Call the responsible Customer Service if you are unable to rectify the fault yourself.
Please provide your Bizerba customer service point with the following details:
– Machine type (see rating plate),
– Machine number (see rating plate),
– Error description.
This will facilitate preparations by customer service staff.
To Next Page
Loading...