Bizerba FK 23 - Routine Servicing and Checks

Operating instructions FK 23 Maintenance
6.066.98.5.10.05 en 8 - 7
8
Then loop it over the upper wheel and place it on the drive disk by routing it through
the deflectors.
Check the position of the saw blade in the guidance and on the wheels.
Tension saw blade, bring clamping unit lever
4
in position 1.
Push product pusher
3
on bolt and engage it in required position.
Insert collecting bin
2
in saw door.
Close saw door
1
at handle (magnet lock).
The machine is ready for operation.
8.6 Care of machine, servicing, maintenance
The drive and the movable parts of the saw are maintenance free.
If saw blade is twisted after uninstalling, it has to be replaced.
The following maintenance activities have to be carried out:
Replace saw blade if necessary.
Removing the saw blade, see chapter 8.2.
Mounting the saw blade, see chapter 8.5.
Checking the saw blade, see chapter 5.6.1.
Check correct functioning of saw blade deflector and drive disk deflector.
Replace saw blade deflector and drive disk deflector if necessary.