Bizerba FK 23 - Saw Blade Alignment Check

Machine and operating elements Operating instructions FK 23
5 - 4 6.066.98.5.10.05 en
5
This setting should be checked from time to time, particularly after a saw blade change.
Changing settings
Fig. 12: Adjust saw blade
Loosen locking lever on rear side.
Turn the star knob to slightly change the
position of the upper wheel.
Turn the disk wheels by hand and check
effect.
Repeat process until the saw blade run
is correct.
Fasten setting with locking lever.
7
Upper wheel
8
Saw blade guide