Operating instructions FK 23 Operation
6.066.98.5.10.05 en 6 - 3
6
Fig. 16: Saws
Using your left hand, move product
against saw blade with product pusher.
Feed product by holding it with your
right hand.
Saw blade! Risk of injury.
Do not put your fingers into the sawing
field.
After cutting, withdraw product, move to-
wards gauge plate and repeat proce-
dure as described above.
Feed end pieces toward blade together
with new product.
Switch off machine.
For periods during which the machine is not in use and after work is completed,
the saw blade should be without tension:
Bring clamping unit lever in position 0, see figure on page 5 - 3.
For hygienic reasons empty the collecting bin from time to time and rins
it.
To Next Page
Loading...