Operation Operating instructions VS12D /C /-R /-V /-
V/R
6 - 4 6.083.98.5.10.10 en
6
Fig. 20: Inserting the product
Using the left hand, position product
against carriage rear wall and push
against holder.
With the right hand, push lever of the
holder downwards causing prongs to
enter the product and holding it firmly.
Transport product towards gauge plate.
Fig. 21: Inserting the product
Position product support against prod-
uct.
Set slice thickness at knob.
Switch on machine.
Depositing program <Stacking 1 time> is
the default setting.
Select desired function on membrane
keyboard.
Depositing table and depositing arm
move towards their initial position.
Set <carriage stroke> and
<carriage speed> or change after start.
Fig. 22: Slicing the product
Start <carriage drive>.
The carriage starts moving, the slices are
placed on the depositing table based on
program settings.
Drive is automatically turned off in the fol-
lowing instances:
– Maximum stacking height or number
of slices is reached
– End of sliced products
– End of program
Once the slicing process is completed set slice thickness to "0".
Switch off machine.
To Next Page
Loading...
