Operating instructions VS12D /C /-R /-V /-
V/R
Maintenance
6.083.98.5.10.10 en 8 - 21
8
Preparing the machine for operation. See chapter 8.5.
WARNING Missing components!
The operator can only be protected from injuries and the machine
protected against damage if all the components of the machine are
assembled properly.
– Check if the machine is complete before it is re-started.
– Check if components are positioned correctly and firmly.
– Only use original Bizerba spare parts and accessories.
8.7 Care of machine, servicing, maintenance
The entire machine must be thoroughly cleaned based on usage, but at least twice a
day.
Re-sharpen blade if necessary.
When necessary, clean or exchange sharpening stones. Caution! Left-handed
thread!
Fig. 68: Maintenance
Slightly lubricate
toothed bar of table
guide once a week with oil from the ac-
cessories kit.
At an annular gap of 6 mm between the blade and the guard ring, the
sharpener no longer has a sharpening effect and the blade has to be re-
placed.
WARNING Changing the blade!
Severe injuries and damage to property.
– For safety reasons, the blade may only be changed by Bizerba
customer service.
– Wear cut-proof gloves and shoes with toe caps.
To Next Page
Loading...
Need help?
General
