Maintenance Operating instructions VS12D /C /-R /-V /-
V/R
8 - 20 6.083.98.5.10.10 en
8
8.6.6 Removing sharpener
Pull sharpener back after loosening the star grip screw and remove to the top.
Set slice thickness immediately to "0".
8.6.7 Removing sharpening dust
– Slice thickness to "0"
– Power plug is pulled
– Wear cut-resistant gloves
– Blade cover removed
Fig. 66: Blade cleaning
Press dry disposable cleaning towel to
blade surface and slowly clean from
center to outside.
Clean the back of the blade in the same
manner.
Fig. 67: Blade guard ring
From the front, insert a dry disposable
cleaning cloth between the blade and
the guard ring.
Use your hands to turn the blade and
the disposable cleaning cloth; while you
are doing so, press the cloth lightly
against the inside of the guard ring.
Machine housing:
Remove sharpening dust from the surfaces with either a dry disposable cleaning cloth
or brush.
If necessary, carry out a complete cleaning cycle.
To Next Page
Loading...
Need help?
General
