BK Precision 5492 - Page 79

79
Description : Set the primary display to diode with continuity test.
CONFigure[:SCALar]:FREQuency [<numeric value>] [ [ ,@1] | ,@2 ]
Description : Set the primary and secondary display to frequency measurement function.
The <numeric value> parameter is used to configure the measurement range.
[ [@1] | ,@2 ] has the same syntax as SCPI <channel_list> syntax. Use @1 to
select the primary display function, and @2 to select the secondary display
function.
Parameter : <numeric value> ;For frequency range : 1200, 1.2E+4, 1.2E+5, 1E+6 Hz.
[ [ ,@1] | ,@2 ] ;For the primary and secondary display setting.
Example : CONF:FREQ 1.2E+4 ;Set the primary display to frequency 12KHz range.
CONF:FREQ 1200 ;Set the secondary display to frequency 1200Hz
range.
CONFigure[:SCALar]:RESistance
[:2W] [<
numeric value>]
:4W [<
numeric value>]
Description : Set the primary display to 2-wire or 4-wire resistance measurement function.
The <numeric value>
parameter is used to configure the measurement range.
Parameter : <numeric value> ; For resistance range : 120, 400, 1200, 4000, 1.2E+4, 4E+4,
1.2E+5, 4E+5, 1.2E+6, 4E+6, 1.2E+7, 4E+7, 1.2E+8, 3E+8
Example : CONF:RES 1.2E+4 ; Set the primary display to resistance 12kΩ range.
CONFigure]
[:SCALar]
:FUNCtion? [ [ ,@1] | ,@2 ]
Description : Return the measurement function. Use @1 to select the primary
display function, and @2 to select the secondary display function.
Response :
<literal> format ; Return the type string :
1. DCV ( DC voltage function )
2. ACV ( AC voltage function )
3. AC+DCV ( AC+DC volts coupling mode )
4. DCA ( DC current function )
5. ACA ( AC current function )
6. AC+DCA ( AC+DC volts coupling mode )
7. Hz ( Frequency function )
8. RES2W ( Resistance 2-wire function )
9. RES4W ( Resistance 4-wire function )
10. DIOC ( Diode with Continuity test )
11. NONE ( No function, only for secondary display )