33
Using the and arrow keys to add or minus the time by 1. Long time pressing
and arrow keys can move the current cursor to left or right. The setup is promptly
effective once modified.
NOTE: when the setting is not 0000, the higher the setting time, the DCR measurement speed
becomes more slowly. It is suggested to set the time to 0000.
Default setting: 0000
Beep Sound Setting (bEEP)
The “bEEP” menu option allows the user to enable or disable the beep sound for every key
press.
Note: This option only disables the beep sound for each key press. It does not disable the beep
sound for “Static Recording” and “Tolerance” mode, as well as the “auto power-off” warning.
To turn ON the beep, push either the or arrow keys until the secondary display
shows “ON”.
To turn OFF the beep, push either the or arrow keys until the secondary display shows
“OFF”.
Default Setting: ON
Auto power-off Setting (AoFF)
The “AoFF” menu option allows the user to select the auto power-off timer. This timer is
always counting continuously. It resets every time a button is pressed or if an action occurred.
If the meter is left untouched or unattended, the timer will count until the configured time is
up. This is particularly important if the user wants to preserve battery life or run the meter
continuously without interruption.
Note: When the timer has reached the configured time, the meter will make an audible “beep”
sound continuously for 10 seconds before auto power-off. To stop the “beep” sound, simply
press any button to resume operation and reset the timer count.
The available timer settings are: 5 minutes, 15 minutes, 30 minutes, 60 minutes, and off.
When the primary display shows “AoFF”, push the or button to select the timer
setting. The settings will be shown on the secondary display as follows:
To Next Page
Loading...
Need help?
General
