MNS-BB Software User Guide
-110-
LE2425A(auth)##show auth ports
Port Status Control Initialize Current State
================================================================
1 Enabled Auto Deasserted Authorized
2 Enabled ForcedAuth Asserted Unauthorized
3 Enabled Auto Deasserted Authorized
4 Enabled Auto Deasserted Unauthorized
5 Enabled Auto Deasserted Unauthorized
6 Enabled Auto Deasserted Unauthorized
7 Enabled Auto Deasserted Unauthorized
8 Enabled Auto Deasserted Unauthorized
9 Enabled Auto Deasserted Unauthorized
10 Enabled Auto Deasserted Unauthorized
11 Enabled Auto Deasserted Unauthorized
12 Enabled Auto Deasserted Unauthorized
13 Enabled Auto Deasserted Unauthorized
14 Enabled Auto Deasserted Unauthorized
15 Enabled Auto Deasserted Unauthorized
16 Enabled Auto Deasserted Unauthorized
17 Enabled Auto Deasserted Unauthorized
18 -- -- -- --
19 -- -- -- --
20 -- -- -- --
21 -- -- -- --
22 -- -- -- --
23 -- -- -- --
24 -- -- -- --
25 Enabled Auto Deasserted Unauthorized
-- Port not available
LE2425A(auth)##auth disable
802.1X Authenticator is disabled.
Authserver:
This command specifies the RADIUS server’s IP address, physical port assignment, UDP port and
shared secret password.
Note: The Authenticator will not be enabled globally if the RADIUS auth server IP and physical ports
are not supplied initially.
Syntax: authserver [ip=<ip-addr>] [udp=<num>] [secret=<string>]
LE2425A(auth)##authserver ip=192.168.1.239 secret=secret
Successfully set RADIUS Authentication Server parameter(s)
LE2425A(auth)##show auth config
802.1x Authenticator Configuration
========================================
Status : Enabled
RADIUS Authentication Server
========================================
IP Address : 192.168.1.239
UDP Port : 1812
Shared Secret : secret
Backend:
This command configures parameters needed by the authenticator when communicating the
authentication protocol with the backend RADIUS authentication server.
To Next Page
Loading...
