MNS-BB Software User Guide
-111-
Syntax: backend port=<num|list|range> supptimeout=<1-240>] [servertimeout=<1-240>]
[maxreq=<1-10>]
port – [mandatory] – ports to be configured
supptimeout – [optional] This is the timeout in seconds the authenticator waits for the supplicant to
respond back. Default value is 30 seconds. Values can range from 1 to 240 seconds.
servertimeout – [optional] This is the timeout in seconds the authenticator waits for the backend
RADIUS server to respond back. The default value is 30 seconds. Values can range from 1 to 240
seconds.
maxreq – [optional] The maximum number of times the authenticator will retransmit an EAP
Request packet to the Supplicant before it times out the authentication session. Its default value is 2; it
can be set to any value in the range from 1 to 10.
LE2425A(auth)##backend port=2 supptimeout=45 servertimeout=60 maxreq=5
Successfully set backend server authentication parameter(s)
LE2425A(auth)##show-port backend
Port Supp Timeout Server Timeout Max Request
(sec) (sec)
=================================================
1 30 30 2
2 45 60 5
3 30 30 2
4 30 30 2
5 30 30 2
6 30 30 2
7 30 30 2
8 30 30 2
9 30 30 2
10 30 30 2
11 30 30 2
12 30 30 2
13 30 30 2
14 30 30 2
15 30 30 2
16 30 30 2
17 30 30 2
18 -- -- --
19 -- -- --
20 -- -- --
21 -- -- --
22 -- -- --
23 -- -- --
24 -- -- --
25 30 30 2
-- Port not available
portaccess:
This command configures PAE or port access authentication parameters used when
authenticating supplicants.
Syntax: portaccess port=<num|list|range> [quiet=<0-65535>] [maxreauth=<0-10>]
[transmit=<1-65535>]
port – [mandatory] – ports to be configured
quiet – [optional] This is the quiet period, the amount of time in seconds the supplicant is held after
an authentication failure before the authenticator retries the supplicant for connection. The default
value is 60 seconds. Values can range from 0 to 65535 seconds.
To Next Page
Loading...
