MNS-BB Software User Guide
-125-
SNMP Coldstart trap sent to a.b.c.d I
SNMP Warmstart trap sent to a.b.c.d I
SNMP Port X link up trap sent to a.b.c.d A
SNMP Port X Link down trap sent to a.b.c.d A
SNMP Configuring IP address in trap receivers list failed D
DEVICE Timezone set to x I
DEVICE Country set to x (no DST) I
DEVICE Country set to x (DST valid) I
DEVICE Time set to x : y : z (HH:MM:SS) tz = a I
DEVICE Date set to x : y : z (HH:MM:YYYY) I
RMON RMON init is done I
BRIDGE Bridge MIB init is done I
TCP/IP Duplicate IP a.b.c.d sent from MAC address
XXXXXX
C
TCP/IP IP packet of version X is dropped I
TCP/IP IP packet from a.b.c.d , with checksum error dropped D
TCP/IP Bad IP fragments from a.b.c.d dropped D
TCP/IP UDP checksum error in the received packet a.b.c.d D
TCP/IP TCP checksum error in the received packet a.b.c.d D
TCP/IP Unable to allocate memory for an ICMP packet C
TCP/IP ICMP checksum error in the received packet D
SNTP Time synchronized through SNTP I
RMON history : control entry X is set to valid I
RMON history : control entry X is set to invalid I
RMON Event : entry X is set to valid I
RMON Event : entry X is set to invalid I
RMON Alarm : entry X is set to valid I
RMON Alarm : entry X is set to invalid I
RMON Alarm : internal error , unable to get memory F
RMON Alarm : internal error, unable to get memory for
alarm entry
F
RMON History : internal error, unable to get memory for
history control entry
F
RMON History : internal error, unable to get memory for
history data entry
F
RMON History : internal error, unable to get memory F
RMON Event : unable to get memory for event entry F
RMON Alarm : unable to get memory for RMON logs F
DEVICE Ethernet DMA init failure F
DEVICE Ethernet hardware error F
DEVICE Ethernet interrupt init failure F
DEVICE Ethernet counters init failure C
BRIDGE Unable to delete MAC address from FDB D
BRIDGE Unable to insert MAC address to FDB D
DEVICE Unable to access ethernet counters C
DEVICE Unable to allocate ethernet memory F
DEVICE Port X link down A
DEVICE Port X link up A
PS INTRUDER a:b:c:d:e:f @ port X , port disabled A
PS INTRUDER a:b:c:d:e:f @ port X , port disabled A
PS Resetting MAC a:b:c:d:e:f at port X failed C
PS Unable to delete learnt MACs in hardware D
PS Port security enabled A
PS port security disabled A
VLAN pvlan:vlan X enabled I
VLAN pvlan:vlan X disabled I
VLAN pvlan:vlan X deleted I
VLAN pvlan:port based VLAN started I
To Next Page
Loading...
