bluelab Pro Controller Wi-Fi - Calibrate Mode

2.5.7 Calibrate
Calibrate mode allows calibration of the Bluelab Pro Controller to conductivity and pH
probes.
1.
Select ‘calibrate’ mode.
2. Select measurement to
calibrate (‘’). Either
Conductivity or pH.
3. Follow the directions in
section 6 of this manual.
Please always clean before calibration. Refer to section 6 for
cleaning and calibration instructions.
pH
p
robe
Calibration is important before
first
use, and is then required regularly to
ensure pH measurements and dosing are accurate. Bluelab recommend that you
calibrate pH every 30-days. To help remind you the Pro Controller has a built in 30
calibration timer.
Conductivity probe is factory calibrated. It is unlikely that you will need to calibrate it,
but it can be calibrated if required. Often cleaning the probe is all that is required.
Please always clean before calibration. Refer to section 6 for cleaning and calibration
instructions.
Calibrate
mode
selected
2.9
7.0