bluelab Pro Controller Wi-Fi - Control Mode; Brightness Control

2.5.8 Control
When in control mode, the Bluelab Pro Controller monitors the actual readings
from the probes and triggers dosing cycles to reach and maintain the measurement
values set in the ‘Required/ Alarms’ mode.
For dosing to occur a separate doser (not included) must be connected to the
Bluelab Pro Controller with the dosing cable provided.
1.
Select ‘Control’ mode.
2. The Bluelab Pro
Controller triggers
dosing in order to reach
and maintain the
nutrient, pH and
temperature values set
in the required/alarms
mode.
When the system is
dosing the control
direction indicator LEDs
will flash.
2.6 Brightness control
1.
Press
the
‘
Settings
’
button.
2. Press the br selection button.
3. Adjust the brightness by using the
increase/ decrease buttons.
4. Press the ‘Settings’ button to save
brightness level.
18
1.1
Control
mode
selected
5.8
0.9
16
5.9
Required
Actual
data
prou
br