1.2 What’s in the box?
1x Bluelab Pro Controller Wi-Fi
1x Getting started guide
1x Universal Power supply 24 VDC output
1x Conductivity Probe with 2 m (6') cable
1x pH Probe with 2 m (6') cable
1x Temperature probe with 2 m (6') cable
1x Alarm and external lockout cable
9x Calibration solution sachets
4x Mounting Screws
1.3 How it works
The Bluelab Pro Controller is designed to continually monitor and control the
conductivity, temperature and pH values of a solution.
It measures these using a separate probe for each parameter and using a connected
dosing system it can dose nutrient and pH correction solutions. The Bluelab Pro
Controller may also control a heating or cooling system via a connected Bluelab
PowerPod.
Actual readings / values
These are the current values measured by the conductivity, temperature, and pH probes.
Required readings / values
These are the target values or set points the Bluelab Pro Controller will maintain
within the reservoir for conductivity, temperature, and pH when in Control mode.
Dosing cycles
Automated control of conductivity, pH and temperature is achieved by dosing. The
Bluelab Pro Controller does this with a dosing cycle method that consists of an on
time and an off time.
OnTime
The time that the pump runs for in each dosing cycle. Or in the case of temperature,
how long the heater or cooler is turned on for. As a guide, three dosing cycles should
change the reservoir by 0.1 pH points.
OffTime
The delay time between each dose (or OnTime). This gives the system time to mix the
stock solution into the reservoir thoroughly, so the Bluelab Pro Controller measures
the solution accurately. Start with a longer OffTime and reduce it over time.
To Next Page
Loading...
Need help?
General
