BLUM MINIPRESS P Operator's Manual

24 BA-106/1EA M53.10XX
8 - Troubleshooting
Error Cause Solution Comment
Boring depth does
not match setting
Boring depth set incorrectly Correct boring depth setting See point 4.1.5
Drill bit length does not match
Drill bits not completely pushed into the
chuck
Work piece thickness does not cor-
respond to the given value (e.g. 15 mm
instead of 16 mm)
Machine is driving against an object (e.g.
ruler stop)
Drill bit length set to 57 mm
Clean dirt from chuck and completely insert
drill bit
Check work piece thickness, correct boring
depth setting, use boring depth stop
Remove object
See point 4.1.2
See chapter 4
See chapter 4
none
Drill/press stroke switch was released
before the boring depth was reached
Work table height (thickness)
Stroke brake set too high
The ruler stops were not set properly on
the ruler.
Keep drill/press stroke switch engaged until
the boring depth has been reached
Work table should be 24 mm thick
Open flow control valve slightly
Check positions and stops and correct if
necessary
none
See chapter 9 -
Appendix
See p oint 4.1.10
none
Ruler not set properly Set ruler to the 0 point See point 2.1.3
Chips between the ruler and the work
piece
Remove dust and chips none
Extension ruler is not attached properly Check ruler attachments and extension -
check spacing of both rulers
none
Swivel gear not engaged Allow index pin to engage See point 4.1.3
Borings are off
center or in the
wrong position

BLUM MINIPRESS P Specifications

General

Brand	BLUM
Model	MINIPRESS P
Category	Power Tool
Language	English