BLUM MINIPRESS P Operator's Manual

4 BA-106/1EA M53.10XX
B - Table of contents
1. Machine information
A - Limited warranty 3
B - Table of contents 4
C - How to use this manual 5
D - Safety information 6
D.1 - Safety decals 6
D.2 - Intended use 6
D.3 - Safety instructions 6
E - Orientation diagram 8
2 - Machine setup 10
2.1 - Unpacking and assembly 10
2.1.1) Machine space requirement 10
2.1.2) Unpacking machine and attaching to a suitable table 10
2.1.3) Positioning (2.2) base ruler 10
2.1.4) Attaching ruler stops 10
2.1.5) Attaching work table 10
2.2 - Connecting to compressed air system 11
2.2.1) Connecting air supply 11
2.2.2) Setting operating pressure 11
2.3 - Electrical connection 11
2.3.1) Electrical connection 11
2.3.2) Checking motor rotation 11
2.3.3) Correcting motor rotation 12
2.4 - Dust extraction 12
2.4.1) Connecting extraction system to the machine 12
3 - Operator panel 13
3.1 - Description of operator panel 13
3.1.1) Designation of operating elements 13
3.1.2) Drill/press stroke button (3.2) 13
3.1.3) Clamp button (3.2) (optional) 13
4 - Hinge installation 14
4.1 - Concealed hinge installation 14
4.1.1) Required parts 14
4.1.2) Setting drill bit length 14
4.1.3) Setting boring pattern 14
4.1.4) Inserting drill bits 14
4.1.5) Setting boring depth 14
4.1.7) Boring depth stop (4.11) 15
4.1.8) Setting speed of downward stroke 15
4.1.9) Checking stroke brake 15
4.1.10) Setting the stroke brake 15
4.1.11) Setting the boring distance 16
4.1.12) Calibration of boring distance 16
4.1.13) Setting swivel stops (optional) (2.7) 16
4.1.14) Placing door on the work table and pushing up against the stop 16
4.1.15) Setting clamps (optional) (4.17) to the material thickness 17
4.1.16) Attaching insertion ram to swing arm (4.8) 17
4.1.17) Clipping concealed hinge on to the insertion ram 17
4.1.18) Boring 17
4.1.19) Checking the tilt adjustment of the swing arm (4.8) 18
4.1.20) Inserting the concealed hinge 18
5 - Mounting plate installation 19
5.1 - Wing mounting plate installation 19
5.1.1) Required parts 19
5.1.2) Setting drill bit length 19
5.1.3) Setting boring pattern 19
5.1.4) Installing drill bits into the chuck 19
5.1.5) Checking boring depth setting 19
5.1.6) Setting the stroke speed 19
5.1.7) Setting the boring distance 19
5.1.8) Setting the ruler stops (2.7) 19
5.1.9) Placing cabinet side on the work table and pushing up against the stop 20
5.1.10) Setting clamps (optional) (4.16) to the material thickness 20
5.1.11) Boring 20

BLUM MINIPRESS P Specifications

General

Brand	BLUM
Model	MINIPRESS P
Category	Power Tool
Language	English