Bjong – User Manual – V1.0 - pg.20
4. Unscrew the three screws highlighted in the figure to remove the battery holder:
5. Remove the flat batteries and replace them with new ones respecting the polarity (positive at the
top);
6. Screw the battery holder into place and reconnect the connector;
7. Close the case.
The batteries in use are of the non-rechargeable high capacity type.
Replace all batteries at the same time, using only new batteries of the same brand and of the
same voltage / capacity.
Using different types of batteries or partially used batteries can cause serious damage to
things and people due to possible explosions.
B.M. Tecnologie Industriali is not liable for any damage caused to incorrect installation and /
or use.
By inserting the batteries in the battery holder, make sure that the external insulation is not
damaged. If in doubt, apply insulating tape to the outer area at the positive pole.
Do not try to charge primary batteries.
There is a danger of serious damage to property and people due to possible explosions.
The series or parallel configuration is determined by the type of battery holder.
Contact the assistance service of B.M. Industrial technologies for different types of battery
holders or in case of doubts about the possible configurations.
To Next Page
Loading...