Bjong – User Manual – V1.0 - pg.35
11.4.4 Codes and Passwords
Codes and password used in EasySetup, are necessary to access some definite functions. The table below
is a resume, detailed functions are explained in their referring paragraphs.
Wi-Fi Connection to the device
SSID (network name): written on the external label
Password (default): users password
Reset to factory settings
11.5 Wi-Fi Connection to the device
The connection to the instrument takes place via a Wi-Fi network with the name (SSID)
BJONG_xxxxxxxxxxxx, where instead of the x there will be the instrument’s ID shown on a special label
stick outside the case.
EasySetup allows you to connect and manage all the instruments of the Bjong and Kaptor
MINI
family.
Using the appropriate connection button on the status bar, the App searches for available Wi-Fi networks
and show only those whose name begins with BJONG and MKP in order to exclude those that are certainly
not generated by Bjong and other managed instruments.
Among those present, the one of interest must be selected.
If your device is not listed among the available connections, pls check its status LEDs to check
if it is ready for connection.
If the list of available connections is empty, check if the tablet’s localization is active.
Android
TM
requests these services to be active in order to generate a list of available Wi-Fi
networks.
It is possible to connect via Wi-Fi to the device by using the Wi-Fi manager of Android
TM
.
Default password is users password.
For an optimal Wi-Fi connection, keep the table at leats 50 cm from Bjong.
For a better connection, it could be asked to disable mobile data.
In fact, on many mobile phones/tablets, Android favors the connection that can guarantee
access to the Internet. In these cases the connection with the instrument would be ignored.
To Next Page
Loading...