BM BJONG - Appendix A - Batteries; Battery Charging

Bjong – User Manual – V1.0 - pg.74
19 Appendix A – Batteries
Below is a comparative table of the range of batteries currently supplied by B.M. Tecnologie Industriali.
Contact the support service for an updated list or for information on optimal use.
Chemical component
Lihtium
Lihtium
Lihtium
Lihtium
Lihtium
Tension
3,6V
3,6V
14,4V
11,1V
14,4V
Capacity
26Ah
52Ah
13Ah
60Ah
57Ah
Rechargeable



✓

Position
internal
internal
internal
external
external
Analog inputs
✓
✓
✓
✓
✓
Digital input
✓
✓
✓
✓
✓
Digital events
✓
✓
✓
✓
✓
Built-in pressur e sensor
✓
✓
✓
✓
✓
Sensors connected to
RS485 port


✓
✓
✓
19.1 Battery charging
Battery must be charged only with our battery charger, by following these steps:
1. Connect the battery charger cable to the battery case;
2. Connect the network cable (220Vac) to the battery charger and to a standard mains socket;
3. LED1 on battery charger: RED = battery charger is working;
4. LED2: RED= battery is charging;
5. When LED2 turns GREEN, battery is completely charged;
6. When charging is complete, disconnect the battery charger form mains and then remove all the
used connectors and cables.