BMW HP4 - Page 102

pression) is displayed at posi-
tion 4.
To adjust rebound damping,
press buttons 1 and 2 as ap-
plicable until DDC-RE (DDC-
REAR) is displayed at posi-
tion 3 and "REB:" (Rebound)
is displayed at position 4.
Hold down button 2 until the
reading next to "REB:"/"COM:"
flashes.
Using buttons 1 and 2, adjust
damping as desired.
+1 … +7: Increase damping by
a maximum of seven levels.
-1 … -7: Reduce damping by
a maximum of seven levels.
0: Default settings.
Adjusting damping
characteristic for front
wheel
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Switch to SETUP mode.
Without height sensor on the
front wheel:
To adjust damping, press but-
tons 1 and 2 as applicable un-
til "DDC-FR" (DDC-FRONT)
is displayed at position 3 and
"DMP:" (Damping) is displayed
at position 4.
Press button 2 until the read-
ing next to "DMP:" flashes.
Using buttons 1 and 2, adjust
damping as desired.
+1 … +7: Increase damping by
a maximum of seven levels.
-1 … -7: Reduce damping by
a maximum of seven levels.
0: Default settings.
Without height sensor on the
front wheel:
To adjust damping, press but-
tons 1 and 2 as applicable un-
til "DDC-FR" (DDC-FRONT)
is displayed at position 3 and
"COM:" (Compression) is dis-
played at position 4.
To adjust the rebound stage,
press buttons 1 and 2 as ap-
plicable until "DDC-FR" (DDC-
FRONT) is displayed at posi-
6
100
z On the race track