7
• The “RACK” models must be mounted in 19” cabinet. These components
will provide mechanical, electrical and re protection (only the front panel may
remain accessible).
• IMPORTANT: before any installation, refer to the “technical
characteristics” paragraph.
• Think of making a backup of your programming on the USB key. In case of
incident (breakdown, thunderstorm…), you will just have to restore the backup
to start the time distribution again.
Caution :
• In case of replacement of the CR2032
battery, it is IMPERATIVE to respect the
polarity following the opposite indications.
• There is risk of explosion if the battery is
replaced by a battery of incorrect type.
• Dispose of used batteries according to the
instructions of the manufacturer.
-
+
To Next Page
Loading...
