Bollhoff RIVKLE B2007 - Procedure for Use; Unscrew Button; Use

39
English
3 - Use
The device can be used in all positions, carried by hand or suspended.
Procedure for use
• Install the battery
• Switch the device on, by pulsing on the main trigger
• Position the RIVKLE
®
on the mandrel. A light pressure starts the motor and causes the
automatic screwing of the RIVKLE
®
, then the shutdown (Push-Pull system). Then insert the
RIVKLE
®
into the hole.
• Alternatively, insert the RIVKLE
®
into the hole, then push the mandrel against it in order
to activate the push-pull.
• Press the trigger and hold it until the mandrel has unscrewed from the RIVKLE
®
thread.
KEEP THE TRIGGER PRESSED FOR THE ENTIRE DURATION OF THE CYCLE.
IF THE TRIGGER IS RELEASED, THE INSERTION IS NOT CORRECT
! " # $
Push pull (automatic) Insert Crimp Spin off (automatic)
Unscrew button
• If unscrewing is difficult, use the CENTER (UNSCREW / RESET) button.
To unscrew, hold the button down until the mandrel has fully unscrewed from the RIVKLE
®
thread.