Bollhoff RIVKLE B2007 - Warning List

49
English
7 - Warning list
1
2
3
M1 engine current high Reduce the force
M2 engine current high Contact the Assistance Service
Wrong Battery
Replace the battery and use only the batteries
provided
4 Not Ready, press RESET Press RESET
5 Low Battery Voltage Replace the battery
6 Setting time too long Check the oil level or replace the battery
7 Screwing/unscrewing time too long Contact the Assistance Service
8 Bad M1 Position, press RESET Check the oil level and press Reset
9 Pressure, Please Check Oil Check the oil level
10 Load Not Correct -
11
M1 Motor, High Temperature
Wait a few minutes before resuming work
12 M2 Motor, High Temperature Wait a few minutes before resuming work
13 Drive, High Temperature Wait a few minutes before resuming work
14 Load a Rivet Load a RIVKLE
®
on the mandrel
15 Error communication Contact the Assistance Service
Error communication Contact the Assistance Service16
17 Wrong Battery Replace the battery with a correct one
18
Nose not installed
Check that the nose is correctly installed against
the body
19
Home sensor error
Press "Reset" button to drive the system
to rest position
20
Service required in 5000 cycles
Contact the Assistance Service
21
22
Maintenance service needed
Contact the Assistance Service
or carry out the maintnenance operations
LCD pushbutton pressed Check that the different button are free / body
No.
Text on the display
Solution
In case of abnormal conditions during operation, the "warning" page will indicate the alarm and the
possible solution.