Bollhoff RIVKLE B2007 - Fitting with Standard Capscrew DIN912

36
English
2 - Preparation for use
Fitting with standard capscrew DIN912:
4 3 1
236 803 03 010 236 803 03040 M3 x 45 12.9
236 803 04040
236 803 05040
236 803 06040
NA
M4 x 55 12.9
M5 x 60 12.9
M6 x 65 12.9
M8 x 65 12.9
236 803 04 010
236 803 05 010
236 803 06 010
236 803 08 010
M3
M4
M5
M6
M8
COMMON
ADAPTATOR
236 166 00 300
2
Adjusting the position of the anvil in relative to the mandrel
• The position of the anvil depends on the length of the RIVKLE
®
before setting.
• The position of the anvil should be adjusted as shown in figure 5.
• After adjustment, tighten the anvil locknut (2) to 10 Nm.
OPEN RIVKLE
®
SEALED RIVKLE
®
Flush mandrel on the end of the RIVKLE
®
Thread root single-turn mandrel
Figure 5 - Adjustment of the anvil position
3 1 4
COMMON ADAPTATOR