F30 3n
User triggered Error of Internal PLC. Please check the application man-
ual VPLC.
F0A 10
Data transmission from control unit KP 500 to the frequency inverter
not possible. At least one file must be stored in the control unit.
F0B 13
The communication module was fitted to slot B without disconnection
of the mains voltage, switch mains voltage off.
F0C 40
After 6 warm starts in less than 3 minutes this fault is triggered, due to
the expectation that a faulty programming of the PLC or the function
table is at hand. Additionally the PLC / Function table is stopped (P.
In error occurrence the signal 162 - “Error Signal” is set. The signal can be linked
with inverter functions.
Output signals in error occurrence
Errors are indicated by digital signals.
Error Signal
Monitoring function signals an error which is displayed in
parameter Current Error 259.
1)
For linking with inverter functions
In addition to fault messages mentioned, there are further fault messages. However
these messages are only used for internal purposes and are not listed here. If you
receive fault mes
sages which are not listed here, please contact the BONFIGLIOLI
customer service.
Please store the parameter file on your PC before contacting BONFIGLIOLI.
268 Operating Instructions ACU 06/13
To Next Page
Loading...
Need help?
General
