BONFIGLIOLI ACTIVE Cube ACU 401-15 User Manual

9.8 Language
The parameters are stored in the frequency inverter in various languages. The pa-
rameter description is displayed by the PC control software (e.g. VPlus) in the select-
ed
Language
33.
Language 33
Function
0 - Deutsch Parameter description in German.
1 - English Parameter description in English.
2 - Italiano Parameter description in Italian.
100 -
The language is defined via VPlus (ACU firmware
5.2.0 or higher)
Up to ACU firmware 5.1.11 the language is set via Language 33 = 0,1,2. Starting with
ACU firmware 5.2.0 the texts of the parameters is administered by the PC software
VPlus. When
Language 33 is set to 100, the settings 0,1 and 2 are not selectable.
Firmware version 5.2.0 or higher requires a compatible VPlus version (VPlus 7.38 or
higher).
9.9 Programming
The parameter Program(ming) 34 enables acknowledgment of a fault message and
resetting to the factory settings. The display of the control unit reads "dEFLt" or "rE-
SEt" and the LEDs indicate the status of the frequency inverter.
Program(ming) 34
Function
111 -
Parameter trans-
mission
Control unit P 500 is prepared for parameter transmis-
sion. A connected frequency inverter can receive data
from the control unit.
110 -
Standard opera-
tion
Resetting of control unit KP 500 to standard operation
mode
123 - Reset
The current error message can be acknowledged via
digital input S1IND/STOA or the software parameter.
The display of the control unit reads "rESEt".
4444 - Default
The parameters of the selected configuration, except for
a few exceptions, are reset to the default settings. The
display of the control unit reads "dEFLt".
Parameters Control level 28, Language 33 as well as Configuration 30 are not
changed during resetting to factory settings (
Program(ming) 34 = 4444).
122 Operating Instructions ACU 06/13

BONFIGLIOLI ACTIVE Cube ACU 401-15 Specifications

General

Brand	BONFIGLIOLI
Model	ACTIVE Cube ACU 401-15
Category	Inverter
Language	English