EN
25
Operation
www.bora.com
5 Operation
Observe all safety and warning information during
operation (see Safety chapter).
INFO The cooktops on the BORA Classic 2.0 system
can only be operated in conjunction with cooktop
extractor CKA2.
INFO The cooktop extractor must only be operated
when the grease filter components are installed.
5.1 General and specific operating
instructions
The cooktop extractor and cooktops are operated via
a central operating panel. The operating panel is fitted
with electronic sensor buttons and display panels. The
sensor buttons respond to finger contact (see Appliance
description chapter).
You operate the appliance by tapping the corresponding
sensor button with your finger (touch control) or by a
swipe of your finger (slider operation).
INFO
Not all symbols are displayed on all appliances.
Functions and indicators are authorised
corresponding to the installed appliances.
5.1.1 Special operating instructions for the
Tepan stainless steel grill CKT
Initial operation:
Heat the griddle to 220 °C for approx. 25 minutes
before using it for the first time (= power level 8 for
both grilling zones).
INFO Bothersome odours may be emitted during this
process.
Operating instructions:
INFO Clean the grill surface before using the appliance
for the first time (see Cleaning chapter).
INFO Preheat the grilling zone for 5 minutes before it is
used each time.
INFO During heating or cooling the griddle may make
some noise. This is a normal occurrence.
INFO A fan is built in to the Tepan stainless steel grill
for cooling, guaranteeing a long service life for the
electronic components and rapid cooling of the
grill surface. Different measures have been taken
to keep noise to a minimum, but it cannot be
completely avoided.
INFO During use, the griddle may show signs of
curvature.
INFO During grilling or heating on a high power level,
the griddle may adopt a light brown colour.
5.2 Touch control
INFO The system recognises 3 different touch
commands. It differentiates between brief
touches (tap), longer contact (long press) and
vertical swiping movements with your finger
(swipe).
Touch command applicable to Time
(contact)
Tap (touch briefly) Buttons + slider 0.065 – 0.95 s
Long press (hold down) Buttons + slider 1 – 8 s
Swipe (vertical movement) Slider 0.15 – 8 s
Tab. 5.1 Touch control
If touch commands do not work or are not working
properly, the following should be taken into account:
Tap the touch zones with only one finger.
Ensure that no other parts of your hand are touching
the operating panel when using the controls.
Keep the contact area as small as possible when using
the touch zones.
5.3 Operating the system
5.3.1 Operating principle
Operation Command
Tap a function Activating a function
Long press on a function Deactivating a function*
Swipe (slider) Setting a value (e.g. power level)
Tab. 5.2 Operating principle
5.3.2 Switching on
Long press on the power button until acoustic
signal
The icon lights up and the switching-on animation is
shown in the slider.
Once the system has started successfully, the standard
display appears in the operating panel.
To Next Page
Loading...
