EN
28
Operation
www.bora.com
Changing to another cooking zone
INFO
When you are in cooktop operating mode (colour
mode “red“) and adjust the settings for one
cooking zone, you can immediately change over to
and operate another cooking zone.
Tap another cooking zone within 2 seconds.
The cooking zone lights up in the operating panel
display.
Operation of the second cooking zone is activated.
The first cooking zone is dimmed in the operating
panel display and the previous settings are adopted.
5.5.2 Setting cooking zone power levels
INFO The cooking zone power levels are shown in
the corresponding cooking zone display as a
7-segment font.
INFO Two seconds after the power level is changed, the
operating panel display automatically returns to
the standard display.
The cooking zone power levels can be adjusted in
different ways:
tap on or
adjustment using the slider
by tapping a certain position on the slider
long press on or (adjustment in threes)
Power-level adjustment on cooktops CKFI,
CKI,
CKIW, CKCH, CKCB and CKG
Increasing the power level
Tap the required cooking zone
Swipe upwards to the required power level
or
tap until the required power level is reached
or
tap a higher position on the slider
or
long press on (power level is increased in threes: 0,
3, 6...)
Reducing the power level
Tap the required cooking zone
Swipe downwards to the required power level
or
tap until the required power level is reached
or
tap a lower position on the slider
or
long press on (power level is decreased in threes:
... 6, 3, 0)
INFO The automatic extractor function can be disabled
manually at any time.
Permanently activating the automatic extractor
function
see 5.6 Menu and 5.6.3 menu item 3: Automatic
extractor control
Activating the automatic extractor function for a
cooking session
Tap the fan button .
The fan symbol lights up blue.
An animation appears on the slider.
appears in the 7-segment display.
5.4.4 Switching the fan off
Swipe downwards to power level 0.
or
tap until power level 0 is reached.
or
long press on the fan button .
The automatic after-run function is started if
necessary.
The cooktop extractor fan is switched off.
5.4.5 Switching off the automatic after-run
early
Tap the fan button
or
Tap the minus button
The cooktop extractor after-run function is switched
off.
INFO BORA expressly recommends use of the cooktop
extractor after-run function.
5.5 Operating the cooktops
INFO To be able to operate the cooktops, cooktop
operation must be active in the operating panel
(colour mode “red”).
5.5.1 Selecting cooking zones
INFO With this system you can operate and control up
to 4 cooking zones at the same time.
Tap on a cooking zone.
The system changes to colour mode “red”.
The system switches to the power display.
Cooking zone operation is activated and you can make
settings for the chosen cooking zone.
The additional cooking zone functions appear.
Repeat this process to operate further cooking zones if
necessary.
To Next Page
Loading...
