EN
27
Operation
www.bora.com
5.4.1 Setting the fan power level
The fan power levels can be adjusted in different ways:
tap on or
adjustment using the slider
by tapping a certain position on the slider
long press on or (adjustment in twos)
Increasing the power level
Swipe upwards to the required power level
or
tap until the required power level is reached
or
tap a higher position on the slider
or
long press on (power level is increased in twos: 0,
2, 4...)
Reducing the power level
Swipe downwards to the required power level
or
tap until the required power level is reached
or
tap a lower position on the slider
or
long press on (power level is decreased in twos: ...
4, 2, 0)
5.4.2 Fan power setting
Activating the power setting
Long press on the slider at position 5
or
tap on when power level 5 is active
An animation appears in the slider.
appears in the display (flashing 3x at first and then
continuous).
INFO After 10 minutes, the power setting is
automatically switched back to power level 5.
Deactivating the power setting
The fan power setting is deactivated early if another
power level is set (see Setting the fan power level).
5.4.3 Automatic extractor function
INFO The automatic extractor function automatically
adjusts the extraction performance to the
highest power level used on all cooking zones
that are currently in use. If the power level of a
cooking zone is changed, the extractor power is
automatically adjusted.
INFO On induction cooktops there is a 20-second delay
in the power level adjustment and on all other
cooktops there is a 30-second delay.
5.3.7 Short-time timer (egg timer)
Activating the egg timer
Tap the egg timer button
The time appears in the 7-segment display above the
sliders in hours, minutes and seconds (
:
:
).
The system changes to colour mode “beige”.
The cooking zones in the display are dimmed.
Setting the time
See 5.5.9 Cooking zone timer
Start egg timer
Tap the start button
An acoustic signal can be heard and the set value is
confirmed.
The set time starts to count down.
The operating panel display changes to the standard
display.
The remaining time is shown by the system exact to the
second.
10 seconds before the time runs out, the remaining
time and egg timer button start to flash.
Time lapsed
When the set time has lapsed an acoustic signal is
heard (max. 60 seconds).
The time display and egg timer button flash (max. 60
seconds).
The remaining time is counted down for another 60
seconds maximum (
:
:
...)
INFO You can stop the acoustic signal and flashing
display by tapping the egg timer button.
Deactivating the egg timer early
Long press on the egg timer button
The egg timer function is ended.
The operating panel display changes to the standard
display.
5.4 Operating the cooktop extractor
INFO To be able to operate the cooktop extractor, fan
operation must be active in the operating panel
(colour mode “blue”).
The slider and the fan symbol light up blue in the standard
display.
To Next Page
Loading...
