EN
32
Operation
www.bora.com
5.6 Menu
INFO Below you will find explanations on how to use
the menu and a description of the most important
menu items. You will find the menu items required
for the basic configuration during initial operation
in the installation instructions.
Calling up the menu
INFO
The menu can only be called up if all cooking zones
and the cooktop extractor are inactive. In addition,
there must be no residual heat.
INFO The menu button will only be displayed in the
operating panel when all functions are inactive
and there is no residual heat.
Tap the menu button
The menu is called up and the first menu item is
displayed (colour mode “beige”).
Closing the menu
Long press on the menu button
The menu is closed and the standard display appears.
Menu overview
INFO The BORA Classic 2.0 system only shows the
relevant/applicable menu items according to the
appliance configuration.
Menu item/Description/Selection area Factory
setting
1 Volume of the acoustic signals (10 – 100%) 80%
2 Childproofing feature (On/Off) Off
3 Automatic extractor control (On/Off) Off
4 Duration of the cleaning lock (5 – 30 s) 15 s
5 Duration of the automatic after-run function (0 –
30 min)
20 min
6 Retrieving the software version
7 Retrieving the hardware version
8 System software update
9 Data export
A Show the recirculation filter service life (only in recirculation
mode)
B Show filter type, change filter type and reset filter
service life
C Extraction system operating mode (exhaust air/recirculation
mode)
Tab. 5.4 Menu overview
Navigating the menu
Tap or to go to the required menu item.
If you have chosen a menu item, after 2 seconds the
display automatically changes to the set value.
Time lapsed
An acoustic signal is heard.
The time display
:
:
and the timer symbol
flash briefly.
After the end of the set time, the cooking zone is
automatically switched to power level
.
The residual heat indicator
appears in the cooking
zone display if necessary.
Multi-timer
INFO Different timers can be set simultaneously for all
cooking zones.
If a timer is already active on a cooking zone:
Tap on a different cooking zone
Activate the timer (see “Activating the timer”)
Set the time (see “Setting the time”)
Start the timer (see “Starting the timer”)
5.5.10 Pause function
INFO With the pause function you can briefly pause
the cooking session. The c
ooking session can be
paused for a maximum of 10 minutes. If the pause
function is not deactivated in this time, all cooking
zones are switched off.
Activating the pause function
Tap the pause button
The pause button lights up, all cooking sessions are
paused and an acoustic signal is heard.
The cooking zone indicators are dimmed and flash.
The pause timer is started (max. 10 minutes).
INFO During the pause, the fan function is not
interrupted. Active bridging and egg timer
functions remain active. Active timer functions are
paused
Deactivating the pause function
Long press on the pause button
The pause button is dimmed and a longer acoustic
signal is heard.
The cooking zone indicators light up and stop flashing.
All cooking sessions are resumed at the power levels
set prior to the pause.
To Next Page
Loading...
