EN
29
Operation
www.bora.com
5.5.3 Switching off the cooking zone
Tap the required cooking zone.
Swipe right down to the bottom until
appears in the
cooking zone indicator
or
tap until
appears in the cooking zone indicator.
The residual heat indicator
will then appear.
Switching off a cooking zone quickly (Quick Off)
Long press on the cooking zone
is displayed by the cooking zone indicator for two
seconds.
A longer acoustic signal provides confirmation.
The residual heat indicator
will then appear.
5.5.4 Automatic heat up function
INFO The system automatically determines the heating
time depending on the power level set.
Activating the automatic heat up function
Tap the required cooking zone
Setting the power level (= continuous cooking level)
Tap the heat-up button
The automatic heat up function is activated.
The automatic heat up function symbol is shown
next to the cooking zone.
INFO If the cooking zone power level is increased
while the automatic heat up function is active,
the automatic heat up function remains active. If
the cooking zone power level is decreased while
the automatic heat up function is active, the
automatic heat up function is deactivated.
Deactivating the automatic heat up function early
Tap the required cooking zone
Long press on the heat-up button
The automatic heat up function is deactivated.
The cooking zone changes back to the previously set
power level.
Time lapsed
When the heat up time has lapsed, the previously set
continuous cooking level will be activated.
The heat-up symbol will no longer be displayed.
5.5.5 Power setting
INFO If a cooking zone on one of the cooktops is
operated on the power setting, the second
cooking zone can be operated on power level 5 at
most (exception: on the Tepan stainless steel grill
CKT the power setting can be activated for both
cooking zones).
INFO If after setting a power level on induction
cooktops CKFI, CKI and CKIW no suitable
cookware is detected (pan size recognition) within
9 minutes, the corresponding cooking zone will be
automatically switched off.
Power-level adjustment on the Tepan
stainless steel grill CKT
INFO The Tepan stainless steel grill power levels are
shown in the corresponding cooking zone display
as a 7-segment font (
-
,
). The temperature is
displayed in °C in the multi-function display above
the slider (temperature display).
INFO During the initial heating phase the actual
temperature is shown in the multi-function display
until the target temperature is reached in the
selected cooking zone.
Increasing the temperature
Tap the required cooking zone
Swipe upwards to the required target temperature
or
tap until the required target temperature is reached
or
tap a higher position on the slider
or
long press on (power level is increased in threes: 0,
3, 6...)
INFO During the heating phase the red hot button
flashes, even if the operating panel display
changes to the standard display after 2 seconds.
When the target temperature is reached, it stops
flashing.
Lowering the temperature
Tap the required cooking zone
Swipe downwards to the required temperature
or
tap until the required temperature is reached
or
tap a lower position on the slider
or
long press on (power level is decreased in threes:
... 6, 3, 0)
To Next Page
Loading...
