bora Classic 2.0 system - Page 42

EN
42
Troubleshooting
www.bora.com
Operating situation Cause Remedy
Cooktops
The cooktop is displayed but both
cooking zone displays show an error
E
and an error code is shown in the
multi-function display
No power supply at the cooktop Have a specialist electrician inspect the fuse
and power connection respectively
Faulty generator/electronics Contact the BORA Service team
Cooktop not displayed Cooktop was not recognised Check the communication cable connection
Error codes
E
0
0
2
,
E
0
2
1
,
E
0
3
7
,
E
0
4
1
,
E
4
3
0
–
E
4
3
4
Overheating Switch off the system and leave it to cool
Contact the BORA Service team
Error code
E
0
5
7
Overheating of the Tepan stainless steel grill
CKT
Switch off the system and leave it to cool
Clean the air vents on the bottom of the
appliance
Contact the BORA Service team
The cooktops have no output although
a power level has been set and
d
E
n
0
is displayed
The demo mode is active Contact your BORA dealer or the BORA
Service Team
Tab. 7.1 Resolving a fault
 After troubleshooting try again and check that the problem has been solved.
 With all faults, try restarting the system.
 As a last resort, briefly disconnect the power supply.
INFO During or after an interruption to the power supply, the cooktops may still be hot. In the case of cooktops
CKCH, CKCB and CKG, after an interruption to the power supply the residual heat is not displayed, even if they
were previously in operation and the cooking zones are still hot.
 Should faults arise frequently, contact the BORA Service team (see Warranty, service, spare parts and accessories
chapter) and specify the error number displayed and the appliance type (see Identification plates chapter).
E
= error = information