Bosch CC488 - 3.0 Solution Ultima RF Receiver Interface; Figure 1: RF Receiver (RF 3212;E) Wiring Diagram; Operation

CC488 | Quick Reference Guide | 3.0 Solution Ultima RF Receiver Interface EN | 22
Bosch Security Systems | 6/04 | 4998152446B
3.0 Solution Ultima RF Receiver Interface
Figure 1: RF Receiver (RF 3212/E) Wiring Diagram
1 2
1 = Solution Ultima Control Panel
2 = RF Receiver (RF 3212/E)
Wiring and Power Up:
1. Remove power from the control panel.
2. Connect the RF Receiver to the control panel as shown above using 0.8 mm (22 AWG) or larger wire.
Wire length should not exceed 300 m (1000 feet).
3. Apply power to the control panel. The red LED at the centre of the module turns on.
Operation:
The following describes the status of the module based on the LED condition.
• LED On – Module is functioning normally.
• LED Off – Power failure has occurred or module is not wired correctly.
• LED Turns Off Momentarily – Module acknowledged receiving an RF signal from a remote RF device.