Bosch CL400 - Page 65

Flexible Automation
Power supply modules
3-15
1070 072 143-101
DANGER 3.6
Highly dangerous voltage!
Highly dangerous voltage is present at the input terminals of the power
supply modules NT1, NT2 and NT3!
Switch off the power to the terminals before working on the module!
CAUTION 3.7
Danger to the module!
Do not insert or remove the module when the control is switched on!
This can destroy the module. Switch off or remove the power supply
module of the control, external power supply and signal voltage before
inserting or removing the module!
CAUTION 3.8
Danger to the module!
All ESD protection measures must be observed when using the mo
dule! Avoid electrostatic discharges!
NT3
The NT3 power supply module provides the 5 V and 12 V supply voltages
with a combined maximum power output of 153 W, i.e. the 5 V and 12 V sup
ply voltages may not both be loaded with their maximum current of 26 and
6 A respectively.
NT24
The NT24 power supply module provides the 5 V and 12 V supply voltages
with a combined maximum power output of 99 W, i.e. the 5 V and 12 V sup
ply voltages may not both be loaded with their maximum current of 11.2
and 4.4 A respectively.