Bosch CL400 - Error Messages When Loading

Flexible Automation
Central processing unit ZS400
4-23
1070 072 143-101
D
Load the contents of the data modules from a memory card. The
memory card must be of data modules type for this function.
The contents of all data modules are overwritten. The reference list
and the data module headers are unaffected.
D If identical data modules at the memory card and in the inter
nal RAM memory have different data module lengths, loading
will be aborted with the error message
.
D Data modules present at the memory card but not present in
the internal RAM memory are not loaded.
D Data modules not present at the memory card but present in
the internal RAM memory remain unchanged.
L Actuate Lock output states switch. The position of the switch is of no
consequence.
Loading commences.
The ZS400 reverts to Stop status when loading is complete.
Red Stop LED lights up.
7segment display:
L Switch the ZS400 back to Run with the switch on the front panel.
Error messages when loading
Display
Meaning
upper lower
Loading from the memory card could not be per
formed correctly.
The message remains on display, even when the
ZS400 is back in Run status.
The message can be deleted using the rolling key.
Fig. 4-19 Error messages when loading