Bosch CL400 - Status and Operational Messages

Flexible Automation
Central processing unit ZS400
4-6
1070 072 143-101
4.1.1 Status and rolling
Rolling LED
Rolling key
2figure 7segment
status display
Fig. 4-6 Status and rolling
The 2figure 7segment status display, the rolling key and the rolling LED
form a display and control panel.
The 2figure 7segment status display distinguishes two displays:
D Display for Power On
D Operational messages
Power On
With Power On, the continuing initialisation of the ZS400 is accompanied
with an ascending display from
to on the lower 7segment display. When
initialisation is complete, the display
of the lower 7segment display goes
out to indicate this.
An error of initialisation is indicated by the flashing or static display of a
character between
and .
With error displays
and you may attempt to remedy the fault by starting
the firmware from a memory card. For all other error displays, the ZS400
unit must be returned to out Customer Service department.