Flexible Automation
Power supply modules
3-18
1070 072 143-101
A battery failure is indicated by the 7segment display ZS400 showing a
.
The battery failure must be acknowledged.
L Acknowledge the battery failure with the reset key on the front panel of the
power supply module.
At the same time, a load test of the new battery is carried out. If the 7seg
ment display then still shows a
, the new battery must be faulty.
. The old buffer battery (Lithium battery) must be fed to the special
waste disposal unit under the waste key number 35 325. The condi
tions of acceptance of the waste disposal depot must be observed.
To Next Page
Loading...
