Flexible Automation
Central processing unit ZS400
4-16
1070 072 143-101
The setting of the serial interface is carried out with dip switch S1.
CAUTION 4.3
Danger to the module!
Do not insert or remove the module when the control is switched on!
This can destroy the module. Switch off or remove the power supply
module of the control, external power supply and signal voltage before
inserting or removing the module!
CAUTION 4.4
Danger to the module!
All ESD protection measures must be observed when using the mo
dule! Avoid electrostatic discharges!
12345678
ON
OFF
S1
Fig. 4-13 Dip switch S1 for X31
Use the dip switch S1 to set the transmission format (fig. 4-14), the baud
rate (fig. 4-16) and the control signals (fig. 4-17).
To Next Page
Loading...
